Lexus GS 99-05 Toyota Aristo V300 Ash Tray/Lighter Gauge Pod

Description

GS 300/400/430 Ash Tray/ Lighter Gauge Pod.
This 3D printed part replaces the front ash tray/Lighter trim. This is a direct replacement no cutting or modifications are required. The pods fit 52mm or 2 1/16 gauges. The gauge pods are rotated over and up towards the driver. This will work on any second generation GS 300/400/430. I also make a RHD version of this that fits the 97-05 Toyota Aristo. If you want a RHD version please send me a message.
Installation is simple you pop out the ash tray/Lighter trim and remove the four screws on the back. You only need to reuse two screws on the top to hold it in. No cutting or modifications are required for installation. I designed these with an autometer 52mm gauge which is actually 52.4. If your gauge is too loose add a layer of tape around it until it fits, too tight sand until it fits.
Made out of ABS plastic the same material most of the interior plastic is made of. This is a raw 3D printed part you will see small lines from being made. The part can be sanded and painted and you won't see any lines.
I have many designs for the second generation GS. If your looking for something else check out the rest of my designs.
If you have any questions just ask!